Table of Contents
Advertisement
<P=002>
RADIO OPERATION
STOP
PAUSE
TUNING
BAND
TUNER
POWER
REVIEW
MEMORY
PRESET
/
PRESET
BAND
Manual tuning
1
Set the function switch to TUNER.
2
Select the desired frequency band. (FM ST, FM
or AM)
ST
FM STEREO
FM MONO
To receive an FM stereo transmission, press the
BAND button so that the "ST" indicator on the
j
display lights up.
The "
" indicator lights up when an FM broad-
cast is in stereo.
X
3
Press the TUNING (
the desired station.
Holding it down for more than 0.5 seconds will
cause the frequency to change rapidly until the
button is released.
If the FM reception is poor, press the BAND
button so that the "ST" indicator goes out.
Although the reception changes to monaural, the
sound becomes clearer.
Please note that when the unit is being tuned in
the FM stereo mode, interim station noise as well
as weak stations are suppressed. Only in the FM
monaural mode, can weak and noisy stations be
received.
Aerial adjustment:
FM
PLAY/REPEAT
/
TUNING
/
CUE
/
PRESET
/
TUNING
/
PRESET
TUNING
AM
W
or
) button to tune into
AM
7
QT-CD161H(SUK) TINSE0026SJZZ
Preset tuning
You can store up to 30 stations in memory (30
stations consisting of any combination of FM and
AM stations you like) and recall them at the push of
a button. FM stations can be recalled in either stereo
or mono.
1
Perform steps 1 - 3 of the "Manual tuning" sec-
tion.
2
Press the TUNER MEMORY button.
3
Within 5 seconds, press the PRESET (
button until the preset number to be programmed
flashes in the display.
4
Within 5 seconds, press the TUNER MEMORY
button to store that station in the selected station
preset number memory.
If the "MEMORY" and preset number indicators
go out before the station is memorised, repeat
the operation from step 2.
The preset numbers in step 2 are displayed
starting from the low numbers which have not
been assigned. If the preset numbers are as-
signed in order, step 3 can also be omitted.
If you want to change the station assigned to a
preset number, select that preset number in step
3.
5
Repeat steps 1 - 4 to set other preset stations,
or to change a preset station.
To recall a memorised station
1
Set the function switch to TUNER.
X
2
Press the PRESET (
or
desired preset channel number.
If there are no stations memorised, this operation
can not be performed.
After use:
Set the ON/STAND-BY switch to STAND-BY.
Notes:
When the memory batteries are installed in the
unit, the memory recalls the last station received
even after changing the band selector, setting
the ON/STAND-BY switch to STAND-BY or un-
plugging the unit from AC power.
If the memory batteries are not inserted and the
power is disconnected, the tuner's preset
memories will be erased.
Replace the memory batteries approximately
once a year.
Preset Number
X
W
or
)
W
) button to recall the
Advertisement
Table of Contents
