Power Source; Compact Disc Operation - Sharp QT-CD110H Operation Manual

<P=002>

POWER SOURCE

B
AC power
Connect the AC power lead to the AC power input
socket, then connect the AC power lead plug to an
AC socket.
Notes:
If the unit will not be used for a long period of
time, remove the AC power lead from the AC
socket.
Connection of the AC power lead to the unit
disconnects the batteries.
Never use a power lead other than the one
supplied. Use of a power lead other than the one
supplied may cause an electric shock or fire.
C
Battery power
1
Disconnect the AC power lead, and remove the
battery compartment cover.
2
Insert 8 "D" size batteries (UM/SUM-1, R20,
HP-2 or similar) into the battery compartment.
When inserting or removing the batteries
ë
, push them towards the
Installing the batteries incorrectly may cause the
unit to malfunction.
3
Replace the battery compartment cover.
Precautions for battery use:
Insert the batteries according to the direction
indicated on the rear panel.
Replace all old batteries with new ones at the
same time.
Do not mix old and new batteries.
Remove the batteries if they are weak or if the
unit will not be used for long periods of time. This
will prevent potential damage due to battery
leakage.
Caution:
Do not use rechargeable batteries (nickel-cadmium
battery, etc.).
Battery replacement:
Replace the batteries when they become weak
and/or recording or playback is impaired. This may
occur even though radio broadcasts are audible.
D
SOUND CONTROL
Volume
Rotate the VOLUME control towards right to in-
crease the volume, and towards left to decrease the
volume.
Extra bass (X-BASS)
Set the X-BASS switch to ON to emphasise the bass
region of the frequency spectrum.
Set the X-BASS switch to OFF to cancel the extra
bass mode.
HEADPHONES
Be sure your headphones have a 3.5 mm (1/8")
diameter plug and are between 16 ohms and 50
ohms impedance. The recommended imped-
ance is 32 ohms.
Connect the headphones plug to the PHONES
socket. The speakers will be automatically dis-
connected. Adjust the volume by using the VOL-
UME control.
and
battery terminals.

COMPACT DISC OPERATION

Care of compact discs
Compact discs are fairly resistant to damage, how-
ever mistracking can occur due to an accumulation
of dirt on the disc surface.
Follow the guidelines below for maximum enjoyment
from your CD collection and player.
Do not write on either side of the disc, particularly
the non-label side. Signals are read from the
non-label side. Do not mark this surface.
Keep your discs away from direct sunlight, heat,
and excessive moisture.
Always hold the CDs by the edges. Fingerprints,
dirt, or water on the CDs can cause noise or
mistracking. If a CD is dirty or does not play
properly, clean it with a soft, dry cloth, wiping
straight out from the centre, along the radius.
E-2
QT-CD111H/110H(SEEG) TINSZ0001SJZZ