Power Source; Remote Control - Sharp QT-CD250 Operation Manual

<P=001>
TO

POWER SOURCE

AC power
To AC INPUT
Connect the AC power cord to the AC power input
jack, then connect the AC power cord plug to an AC
outlet.
Notes:
If the unit will not be used for a long period of
time, remove the AC power cord from the AC
outlet.
Connection of the AC power cord to the unit
disconnects the batteries.
Never use a power cord other than the one
supplied. Use of a power cord other than the one
supplied may cause an electric shock or fire.

REMOTE CONTROL

Remote Sensor
8" - 20'
(0.2 m - 6 m)
Battery power
AC 120 V, 60 Hz
To an AC outlet
1
Disconnect the AC power cord, and remove the
battery compartment cover.
2
Insert 6 "D" size batteries (UM/SUM-1, R20,
HP-2 or similar) into the battery compartment.
Insert the batteries according to the direction
indicated on the rear panel.
When inserting or removing the batteries
, push them toward the
Installing the batteries incorrectly may cause the
unit to malfunction.
3
Replace the battery compartment cover.
Note:
Replace the batteries when they become weak
and/or recording or playback is impaired. This may
occur even though radio broadcasts are audible.
1
Remove the battery compartment cover on the
remote control.
2
Insert 2 "AA" size batteries (UM/SUM-3, R6,
HP-7 or similar) into the battery compartment on
the remote control.
When inserting or removing the batteries, push
them toward the
Installing the batteries incorrectly may cause the
unit to malfunction.
Notes:
Replace the batteries if the operating distance is
reduced or if the operation becomes erratic.
Periodically clean the transmitter LED on the
remote control and the sensor on the main unit
with a soft cloth.
Exposing the sensor on the main unit to strong
light may interfere with operation. Change the
lighting or the direction of the unit.
Keep the remote control away from moisture,
excessive heat, shock, and vibrations.
5
QT-CD250(SEC) TINSE0040SJZZ
2
3
1
5
6
4
and
ë
battery terminals.
ë
battery terminals.