Cassette Operation - Sharp QT-CD110H Operation Manual

<P=004>

CASSETTE OPERATION

General information
For playback, use normal or low-noise tape for
the best sound. (Metal or CrO
ommended.)
For recording, use only normal tape.
Do not use C-120 tapes, tapes with large
diameter reels, or poor-quality tapes, as they
may cause malfunctions.
Before loading a tape into the cassette compart-
ment, tighten the slack with a pen or pencil.
Cassettes have removable tabs which prevent
accidental recording or erasing from taking
place. Removing the tab will protect the corre-
sponding side from being erased. Cover the tab
holes with adhesive tape to erase or record
again.
Side A (1)
Tab for side B (2)
F
Tape playback
1
Set the FUNCTION switch to TAPE.
2
Load the cassette into the cassette compart-
ment.
3
Press the PLAY button.
4
To advance the tape, press the STOP/EJECT
button, then press the F FWD button. To rewind,
press the STOP/EJECT button, then press the
REWIND button.
To interrupt playback:
Press the PAUSE button during playback.
Press the PAUSE button again to resume playback.
To stop playback:
Press the STOP/EJECT button.
Precautions:
Be sure not to press the PLAY and REWIND
buttons simultaneously, or the tape will become
damaged.
Before changing from one tape operation to an-
other, press the STOP/EJECT button.
Do not press the PAUSE button whilst the fast
forward or rewind operations are in progress.
The F FWD or REWIND button will not be re-
leased when the tape end is reached. Once this
occurs, press the STOP/EJECT button.
G
RADIO OPERATION
1
Set the FUNCTION switch to AM or FM AUTO.
2
Use the TUNING control to tune in to the desired
station.
tape is not rec-
2
The built-in FM AUTO function automatically
changes reception to monaural if the signal is
weak during FM stereo reception.
Although the reception changes to monaural, the
sound becomes clearer.
After use:
Set the FUNCTION switch to STAND-BY.
Aerial adjustment
FM
Tab for side A (1)
RECORDING
When recording important selections, be sure to
make a preliminary test to ensure that the
desired material is being properly recorded.
The ALC (Automatic Record Level Control) cir-
cuit automatically controls the level of the input
signal used for recording.
The VOLUME and X-BASS controls may be
adjusted with no effect to the recorded signal.
(Variable Sound Monitor)
Metal and CrO
ding.
H
1
Set the FUNCTION switch to CD.
2
Load the cassette into the cassette compart-
ment.
3
Press the RECORD button.
4
Press the PLAY/REPEAT button on the CD.
Notes:
To record a specific track, press the UP or
DOWN button on the CD player until the desired
track number is displayed, and then start recor-
ding.
If the STOP or PLAY/REPEAT button on the CD
player is pressed whilst recording, or if the CD
comes to its end, the tape deck will not stop.
E-4
QT-CD111H/110H(SEEG) TINSZ0001SJZZ
AM
tapes cannot be used for recor-
2
Recording from the built-in CD
player