Cassette Operation - Sharp QT-CD210H Operation Manual

TO <P=001>

CASSETTE OPERATION

Tape playback
ON/STAND-BY
(Function)
1
Set the function switch to TAPE.
2
Load the cassette into the cassette compart-
ment.
3
Press the PLAY button.
4
To advance the tape, press the STOP/EJECT
button, then press the F FWD button. To rewind,
press the STOP/EJECT button, then press the
REWIND button.
To interrupt playback:
Press the PAUSE button during playback.
Press the PAUSE button again to resume playback.
To stop playback:
Press the STOP/EJECT button.
Precautions:
Be sure not to press the PLAY and REWIND
buttons simultaneously, or the tape will become
damaged.
Before changing from one tape operation to an-
other, press the STOP/EJECT button.
Do not press the PAUSE button whilst the fast
forward or rewind operations are in progress.
The F FWD or REWIND button will not be re-
leased when the tape end is reached. Once this
occurs, press the STOP/EJECT button.
RECORDING
When recording important selections, be sure to
make a preliminary test to ensure that the desired
material is being properly recorded.
The ALC (Automatic Record Level Control) cir-
cuit automatically controls the level of the input
signal used for recording.
The VOLUME control may be adjusted with no
effect on the recorded signal. (Variable Sound
Monitor)
Metal and CrO
ding.
STOP
Recording from the built-in CD player
1
Set the function switch to CD.
Load the disc to be recorded.
2
Load the cassette into the cassette compart-
ment.
3
Press the RECORD button.
4
Press the PLAY/PAUSE button on the CD.
To stop recording:
Press the STOP/EJECT button.
The tape will stop.
Note:
If the STOP or PLAY/PAUSE button on the CD
player is pressed whilst recording, or if the CD
comes to its end, the tape deck will not stop.
To record a specific track:
Press the UP or DOWN button on the CD player until
the desired track number is displayed, then start
recording.
5
QT-CD210H(SUK) TINSE0034SJZZ
tapes cannot be used for recor-
2
TUNING
ON/STAND-BY PLAY /
(Function) PAUSE