Table of Contents
Advertisement
Enhancing your system
The audio cable is not included. Purchase a seperate audio cable as
shown below.
Portable audio
player
Computer
To the line output socket
DC IN 6V
Audio cable
(not supplied)
Listening to the audio/video sounds from
portable audio player, computer, etc.
1
Use an audio cable to connect the portable audio player,
computer, etc. to the AUX IN socket.
2
Press the ON/STAND-BY button to turn the power on.
3
Press the FUNCTION button to select AUX.
4
Play the connected equipment.
If volume level of the connected device is too high, sound
distortion may occur. Should this happen, lower the volume of
the connected device.
Notes:
When AUX cable is plugged in, the unit will enter the AUX
function automatically.
To prevent noise interference, place the unit away from the
television.
A
U
X
N I
AUX IN
Troubleshooting chart
Many potential problems can be resolved by the owner without
calling a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
General
Symptom
The clock is not set to the
Is the Summer Time set to the correct
correct time.
setting? (Refer to page 9)
Did a power failure occur? Reset the
clock. (Refer to page 9)
When a button is
Set the unit to the power stand-by
pressed, the unit does
mode and then turn it back on.
not respond.
No sound is heard.
Is the volume level set to "0"?
Remote control
Symptom
The remote control does
Is the AC power lead of the unit
not operate.
plugged in?
Is the battery polarity correct?
Is the battery dead?
Is the distance or angle incorrect?
Is there a strong light shining on the
remote sensor?
USB
Symptom
Device cannot be
Is there any MP3/WMA file available?
detected.
Is the device properly connected?
Is it MTP device?
Does the device contain AAC files
only?
Playback does not start.
Is it a copyright protected WMA file?
Is it a false MP3 file?
Wrong time display.
Is Variable Bitrate file being played
Wrong file name
back?
display.
Is the File Name written in Chinese or
Japanese characters?
Unit always powers on at
Is the AUX cable is plugged in?
AUX function.
DK-UH2
DK-UH2(BK)
ENGLISH
Possible cause
Possible cause
Possible cause
E-18
Advertisement
Table of Contents
