Enhancing Your System - Sharp XL-UH2080H Operation Manual

Enhancing your system

XL-UH2080H
The connection lead is not included. Purchase a commercially avail-
able lead as shown below.
Portable audio player, etc.
34
AUDIO CABLE
(NOT SUPPLIED)
Auto power on function (AUDIO IN):
When you press any of the following buttons, the unit turns on.
AUDIO IN button (main unit and remote control): The unit turns on
and the "AUDIO IN" function is activated.
/ button on the main unit: The unit turns on and playback of
the last function starts (CD,TUNER, AUDIO IN, USB).
Listening to the playback sounds of Portable
Audio Player, etc.
1
Use a connection lead to connect the Portable Audio
Player etc. to the AUDIO IN socket.
When using video equipment, connect the audio output to this
unit and the video output to a television.
2
Press the ON/STAND-BY button to turn the power on.
3
Press the AUDIO IN button.
4
Play the connected equipment.
If volume level of the connected device is too high, sound
distortion may occur. Should this happen, lower the volume of
the connected device.
If volume level is too low, increase the volume of the connected
device.
Note:
To prevent noise interference, place the unit away from the
television.
Headphones
Do not turn the volume on to full at switch on. Listen to music at
moderate levels. Excessive sound pressure from earphones and
headphones can cause hearing loss.
Before plugging in or unplugging the headphones, reduce the
volume.
Be sure your headphones have a 3.5 mm (1/8") diameter plug and
impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.
Plugging in the headphones
automatically. Adjust the volume using the VOLUME control.
disconnects the speakers