Sharp XL-UH2080H Operation Manual page 28

Using the Radio Data System (RDS) (continued)
XL-UH2080H
To recall stations in memory
To specify programmed types and select stations (PTY search):
You can search a station by specifying the programme type (news,
sports, traffic programme, etc. ... see pages 29 - 30) from the stations
in memory.
1
Press the TUNER (BAND) button to select the FM band.
2
Press the RDS PTY button on the remote control.
"SELECT" and "PTY TI" will appear alternately for about 6
seconds.
3
Within 6 seconds, press the PRESET (
select the programme type.
Each time the button is pressed, the programme type will
appear. If the button is held down for more than 0.5 seconds,
the programme type will appear continuously.
4
Whilst the selected programme type is flashing (within 6
seconds), press the RDS PTY button again.
After the selected programme type has been lit for 2 seconds,
"SEARCH" will appear, and the search operation will start.
Advanced Features
28
Notes:
If the display has stopped flashing, start again from step 2. If the
unit finds a desired programme type, the corresponding channel
number will flash for about 4 seconds, and then the station name
will flash for 7 seconds, which will remain lit.
If you want to listen to the same programme type of another
station, press the RDS PTY button whilst the channel number or
station name is flashing. The unit will look for the next station.
If no station can be found, "NOT FOUND" will appear for 4
seconds.
If you select the traffic programme:
If you select the traffic programme (TP) in step 3, "TP" will appear.
(This does not mean that you can listen to the traffic information at
that time.)
When the traffic information is broadcast, "TA" will appear.
or ) button to
To specify station names and select stations manually:
You can select a station by specifying the name (BBC R1, BBC R2,
etc.) from the stations stored in memory.
Before starting this operation, you must store one or more station
names in memory.
1 Press the TUNER (BAND) button to select the FM band.
2 Press the PRESET (
select a desired station.
3 The station name will be displayed for 6 seconds. Then the
display will change.
or ) button on the remote control to