Sharp XL-UH2080H Operation Manual page 26

Using the Radio Data System (RDS) (continued)
XL-UH2080H
Information provided by RDS
Each time the RDS DISPLAY button is pressed, the display will
switch as follows:
Station name (PS)
Frequency
When you are tuning in to a station other than an RDS station or to
an RDS station which sends weak signal, the display will change in
the following order:
NO PS
FM 98.80 MHz
26
Programme type (PTY)
Radio text (RT)
NO PTY
NO RT
Using the Auto Station Programme Memory
(ASPM)
Whilst in the ASPM operation mode, the tuner will automatically
search for new RDS stations. Up to 40 stations can be stored.
If you have already stored some stations in memory, the number of
new stations you can store will be less.
1
Press the TUNER (BAND) button to select the FM band.
2
Press and hold down the RDS ASPM button on the remote
control for at least 3 seconds.
1 After "ASPM" has flashed for about 4 seconds, scanning will
start (87.50 - 108.00 MHz).
2 When an RDS station is found, "RDS" will appear for a short
time and the station will be stored in memory.
3 After scanning, the number of stations stored in memory will
be displayed for 4 seconds, and then "END" will appear for
4 seconds.