Projector Status Lights; Cleaning The Lens; Cleaning The Projector Case; Cleaning And Replacing The Air Filter - Epson PowerLite 54C Manual

Projector Status Lights

The lights on top of the projector indicate the projector's status
and let you know when a problem occurs.
Warning light
Power light
Power Warning
light light Status
Flashing
red at
— Internal error
1-second
intervals
Flashing
red at
— Lamp failure
0.5-second
intervals
— Red Overheating
Flashing High
— orange temperature
(quickly) warning
Standby
Orange Off
(sleep) mode
Description
There is an internal error
in the projector. Turn the
projector off and unplug it.
Contact EPSON for help.
The lamp is burned out or
not installed correctly, or
the lamp cover is open.
Close the cover or replace
or reseat the lamp, if
necessary, as described
on page 12.
The projector has
overheated and turned
itself off. Let it cool for a
few minutes, then turn it
back on. Make sure there
is plenty of space around
and under the projector
for ventilation. Also clean
the air filter (see page 11).
If it continues to overheat,
you may need to replace
the air filter.
The projector is too hot.
Make sure the
temperature surrounding
the projector does not
exceed 95 F and there is
plenty of space around
and under the projector
for ventilation. Clean the
air filter, if necessary. See
page 11 for instructions.
The projector is in standby
or sleep mode. You can
unplug it or press the P
Power button to turn it on.
10/03
EPSON PowerLite 54c/74c Projector
Power Warning
light light Status
Flashing
Off Warming up
green
Green Off Operating
Flashing
Off Cooling down
orange

Cleaning the Lens

Clean the lens whenever you notice dirt or dust on the surface.
Use a canister of compressed air to remove dust.
To remove dirt or smears on the lens, use lens-cleaning
paper. If necessary, moisten a soft cloth with lens cleaner and
gently wipe the lens surface.
Caution
Do not use glass cleaner to clean the lens.

Cleaning the Projector Case

Before you clean the case, first turn off the projector and unplug
the power cord.
To remove dirt or dust, wipe the case with a soft, dry, lint-
free cloth.
To remove stubborn dirt or stains, moisten a soft cloth with
water and a mild detergent. Then wipe the case.
Do not use wax, alcohol, benzene, paint thinner, or other
chemical detergents. These can damage the case.

Cleaning and Replacing the Air Filter

Clean the air filter on the bottom of the projector after every
100 hours of use. If it is not cleaned periodically, it can become
clogged with dust, preventing proper ventilation. This can cause
overheating and damage the projector. When the filter is
clogged, the projector displays the message "The projector is
overheated."
To clean the air filter, follow these steps:
1. Turn off the projector, allow it to cool down, and unplug the
power cord.
EPSON PowerLite 54c/74c Projector
Description
The projector is warming
up. Wait for the image to
appear.
The projector is operating
normally.
The projector is cooling
down. Wait for the orange
light to stay on without
flashing before
unplugging it.
11
-