Projector Status Lights - Epson PowerLite Pro Cinema 800 Quick Manual

Epson PowerLite Pro Cinema 800

Projector Status Lights

If your projector isn't working correctly, first turn it off, wait for
the warning light to turn a steady orange, turn off the power
switch on the back, and unplug it. Then plug the power cord
back in and turn on the projector. If this doesn't solve the
problem, check the lights on top of the projector. They alert
you to possible problems.
Power light
Warning light
Light Status Action
off Make sure the power switch on the back of
P
the projector is turned on and the power cable
is connected securely at both ends.
orange The projector is in standby mode. You can turn
P
off the power switch on the back to turn off
the projector or press the P Power button to
turn it on.
flashing The projector is warming up. Wait about
P
green 30 seconds for a picture to appear.
green The projector is operating normally.
P
flashing You've turned off the projector and it's cooling
P
orange down. Wait until the light stops flashing, then
turn off the power switch in back (or press the
P Power button to turn it back on).
flashing High-speed cooling is in progress. If the
orange projector gets too hot again, projection stops
automatically. Make sure there is plenty of
space around and under the projector and
nothing is blocking the air filter. If it continues
to overheat, clean the air filter; see
instructions at right.
red The projector is too hot and the lamp has
turned off. Wait 5 minutes, then turn it back
on. Make sure there is plenty of space around
and under the projector and nothing is
blocking the air filter. Clean or replace the air
filter if necessary.
If you are using the projector at an altitude
above 4900 feet, turn on High Altitude Mode.
flashing red The lamp needs to be replaced. Make sure
(half-second you have a spare lamp handy.
intervals)
flashing red There is an internal problem. Turn off the
at 1-second power switch on the back of the projector and
intervals unplug it. Then conatct Epson for assistance.
8 - Epson PowerLite Pro Cinema 800
Remote Control and IR Codes
Following is an illustration of the remote control, along with
the IR codes that correspond to the remote control buttons:
11/05
Function Hex code
Power on 90h
Power off 91h
Memory 8Bh
Color Mode 8Fh
Menu 9Ah
Aspect 8Ah
Up B0h
Down B2h
Left B3h
Right B1h
Enter 85h
Esc 84h
HDMI 73h
D4/scart 7Eh
Input A 71h
Input B 9Dh
S-Video 9Ch
Video 70h
Contrast 2Ch
Color Temp. 2Dh
Skin Tone 2Ah
Pattern 96h
Blank 93h