Epson PowerLite 54C Manual page 13

Follow these steps to replace the lamp:
1. Turn off the projector.
2. When the power light stops flashing and remains orange,
unplug the power cord. If the projector has been on, allow it
to cool down for at least half an hour (or until the lamp is
cool).
Warning
Let the lamp cool before replacing it. If the lamp breaks, handle
the shards carefully to avoid injury.
3. Turn the projector upside-down to access the lamp
compartment. Then use the screwdriver included with the
replacement lamp to slide the edge of the lamp cover towards
the side of the projector. Then lift off the cover.
4. Use the screwdriver to loosen the two screws holding the
lamp in place. The screws are deep inside the projector on
the sides of the lamp. (You can't remove the screws.)
Don't remove these screws
1
2
10/03
EPSON PowerLite 54c/74c Projector
5. Hold the lamp by the top, as shown, and pull it straight out.
Warning
This product includes a lamp component that contains mercury.
Please consult your state and local regulations regarding disposal
or recycling. Do not put it in the trash.
6. Gently insert the new lamp and tighten its screws.
Caution
Do not touch the glass portion of the lamp assembly. Touching
the glass could result in premature lamp failure.
7. Position the lamp cover so the arrows on the lamp cover
align with the arrows on the projector. Then slide in the
cover until it clicks into place.
8. Reset the lamp timer as described below.
EPSON PowerLite 54c/74c Projector
1
2
13
-