Power Indicator - Epson PowerLite 30c User Manual

When Having Trouble
Status
Orange

Power Indicator

Status
Orange
Orange
Green
Green
36
Cause
High-speed (This is not an abnormality, but if the temperature rises too
cooling in high again, projection will stop automatically.)
progress
•
•
Cause
Standby status (Not abnormal)
The power cord should only be disconnected when the
projector is in this condition.
Press the [Power] button to start projection.
Cool-down in (Not abnormal)
progress
•
•
Projection in (Not abnormal)
progress
Warm-up in (Not abnormal)
progress Please wait.
Warm-up time is approximately 40 seconds.
After warm-up is complete, the flashing green indicator
changes to steady green.
•
If the projector is not operating properly even though the indicators are all showing normal
status, refer to "When the Indicators Provide No Help" on the following page.
•
If an indicator is showing a status that does not appear in the previous tables, contact your
dealer or the nearest address provided in the International Warranty Terms brochure that came
with the projector.
Remedy or Status
Set the projector up in a place which is well-ventilated,
and make sure the air filter and exhaust vents are clear.
Clean the air filter.
Remedy or Status
Please wait.
The cool-down period lasts for about 25 seconds.
The [Power] button does not work during cool-down.
Press the button again after cool-down ends.
See Page
p.46
: lit : flashing
See Page
p.8
p.10
p.9
p.9