Servicing & Troubleshooting - Renkus-Heinz CF Series RHAON User Manual

Users Manual
SERVICING and TROUBLE SHOOTING
GENERAL INFORMATION
transducers can be replaced from the front of the column by removing the grille to expose the transducers and their mounting screws.
TROUBLE SHOOTING HINTS
GENERAL
Most RHAON equipped system setup and installation problems are "network problems" and not RHAON problems.
Your Renkus-Heinz loudspeakers were factory tested before they left our factory and barring shipping damage should be in perfect operat-
ing condition.
Nevertheless, it is always a good idea to run a quick check on each loudspeaker before taking it out to the job site and installing it.
If you should run into a problem at the site, it's good to know the problem is in the network or the system wiring and not in the loudspeak-
ers.
The Analog 1 input is always connected so it's a simple matter to connect a line level analog signal to the loudspeaker and check out its
performance.
COMMON AUDIO PROBLEMS
Hum
The most common sources of system hum are the program source or an improper or poor ground on an audio signal line. Check the pro-
gram source to make sure the hum isn't originating there. Carefully check all the audio connections to make sure they are properly made.
Noise
Most noise problems are the result of improper grounding or of noise being induced into the audio signal line from adjacent noise sources,
and turn off all the lights and any other suspected noise sources.
44