Advanced Menu - Epson EMP-TW100 User Manual

Advanced Menu

Video Progressive
Motion Detect
Advanced
Setting Noise Reduction
About Position
Reset All Video Signal
Input A
Input B
Setup Level
Reset
Select Enter
Main menu
Advanced Progressive
Motion
Detect
Noise
Reduction
Position
Video Signal
Input A
Select [ Film/Auto ]
1 2 3 4 5
OFF NR1 NR2
Adjust
Select [ Auto ]
Select
Select
0% 7.5%
Execute
Sub-menu
(Can only be adjusted for 525i and 625i image signals)
Changes signals from Faroudja's interlaced
conversion mode.
OFF :Progressive (IP) conversion is carried out for the screens in
each field. It is designed for use when viewing images with
large amounts of movement. The DCDi function
not operate.
Video :Turns off the Film judgment function . The DCDi
function operates.
Film/Auto :This setting should normally be used. The projector
automatically determines whether the signal source is a
film source or not. If the source is a film source, the 3-2
pull-down function
match the original are reproduced. The DCDi function
operates.
(Can only be adjusted for 525i and 625i image signals)
Switches the three-dimensional Y/C separation function
operating mode for progressive (IP) conversion depending on whether the
images are moving quickly or slowly.
If a lower setting is used, flickering is reduced and images become sharper
and more distinct. This mode is ideally suited for viewing still images.
If a larger setting is used, images are projected more smoothly with less
jerkiness. This mode is ideally suited for viewing moving images. Adjust to
suit the type of images being viewed.
(Can only be adjusted for 525i and 625i image signals)
Reduces image interference and makes the image quality softer. Two
modes are available. Use the setting that best suits the images being
viewed. It is recommended that you set this function to OFF when viewing
images sources such as DVDs which are relatively free from interference.
(Adjustment is not possible when D-RGB signals are being input.)
Moves the image display position vertically and horizontally.
Press the [Select] on either the projector's control panel or the remote
control, and make the adjustment using the display position adjustment
screen that appears.
(Adjustment is only possible when composite or S-Video signals are being
input.)
Sets the video signal format.
Press the [Select] on either the projector's control panel or the remote
control, and select the setting using the menu that appears.
When set to "Auto", the video signal format is set automatically, but if
projecting signals in N-PAL format, the setting needs to be made
manually.
(Can only be adjusted for 525i and 625i input signals)
Selects the type of signal being input to the Input A port.
Video menu Setting menu

Advanced menu

About menu
Function
mode to progressive (IP)
operates so that film images which
and the
Reset All menu
Default
setting
Film/Auto
does
3
OFF
Depends on
connection
Auto
YCbCr
29