Epson EMP-TS10 User Manual page 45

Probable cause
Is the lamp due for replacement?
If the indicator is flashing orange, it means that the
lamp will soon be due for replacement. When the lamp
is nearly due for replacement, the image will become
darker and the tint will become poorer.
Has the image brightness been adjusted
correctly?
Has the image contrast
correctly?
Probable cause
Do the settings for component video
signals match the signals from the connected
device?
If the YCbCr or YPbPr settings are incorrect, the
images may appear greenish.
Probable cause
Is the audio source connected correctly?
Has the correct audio input port been
selected?
Is sound being output from the audio source?
Has the volume been adjusted to the
minimum setting?
Has the A/V Mute function been turned on?
Have the correct USB audio settings for this
projector been made at the computer?
(When connected to a computer)
been adjusted
Condition
Images appear green
input
Condition
No sound can be heard
Remedy
Replace the lamp with a new one. (p.47, 48)
Adjust using the Brightness environment setting menu.
Video - Brightness (p.21, 22)
Adjust using the Contrast environment setting menu.
Video - Contrast (p.21, 22)
Remedy
Use the Comp2/YCbCr Input commands in the Setting
menu to select the signal format that matches the
connected source.
Setting - Comp2/YCbCr Input (p.24)
Remedy
Check that the cable being used matches the input port.
(Setup Guide)
Use the Audio Input command in the Audio menu to
set the port for audio signal input. (p.23)
Check the volume for the audio source.
Adjust the volume so that the sound is audible. (p.18)
The projector may be in A/V Mute mode. Press the [A/
V Mute] button on the projector's control panel or the
remote control to cancel the A/V Mute
If using a USB cable to output sound from the
computer, you need to select USB audio for the
projector in the audio properties for the computer.
mode. (p.30)
43