Adjusting the Screen Image
Correcting Keystone Distortion
When the projector is set up at an angle, keystone distortion may appear in the projected images. If the
projector is adjusted to within a range of approximately 30 vertically or 10 horizontally, the keystone
correction function can be used to adjust this keystone distortion.
The values given here are for when the image is at the smallest zoom setting (telephoto). The maximum
angles will be smaller if the zoom setting has been increased in the wide angle direction. Furthermore, if the
projector has been tilted both vertically and horizontally, the maximum adjustable angle will again be smaller
than the maximum angle if the projector had been tilted in only one direction.
When tilted vertically
Approx. 30 above
When tilted horizontally
Approx. 10 to the right
12
When the foot is adjusted, it may cause the projected images to become distorted. Use the
keystone correction function to adjust this distortion.
If the projector is tilted horizontally, turn the rear adjustable foot to adjust the angle.
Rear adjustable
foot
Extend
Retract
30°
10°
Approx. 30 below
30°
Approx. 10 to the left
10°