h.
Heat sink (see
i.
Modem module (see
j.
System board (see
Remove the ExpressCard assembly:
1.
Turn the system board upside-down, with the front toward you.
2.
Remove the four Phillips PM2.0×5.0 screws that secure the ExpressCard assembly to the system
board.
3.
Detach the slots on the ExpressCard assembly from the tabs on the ExpressCard connector (1).
4.
Remove the ExpressCard assembly (2).
Reverse this procedure to install the ExpressCard assembly.
Heat sink on page
81)
Modem module on page
System board on page
63)
88)
Component replacement procedures
93