Communication Protocol; Usb Connection Setup - Epson ELP-600 User Manual

List of ESC/VP21 Commands

Communication protocol

• Standard baud rate
• Data length
• Parity
• Stop bit
• Flow control

USB Connection Setup

This projector is controlled by ESC/VP21 commands, so if using a USB cable
to connect the projector to a computer, you must carry out the following
preparations beforehand.
Procedure
1 Download the "EMP Link21L" utility software from the EPSON
website.
For details on acquiring the software, please contact one of the service
offices listed in the catalog.
2 The USB driver will be downloaded at the same time. Install this
USB driver to the computer.
For details on installing the software, refer to the EMP Link21L User's
Guide which was downloaded together with the software.
3 Set the "COM Port" setting in the "Advanced" menu to "USB".
Communication via a USB connection will then be possible.
104
: 9600 bps
: 8 bits
: None
: 1 bit
: Xon/Xoff