Advertisement
Assembling Side Burner Shelf, Continued
5.
Hang side burner shelf on side panel by placing
side burner slotted screw holes over the 2 screws
and washers loosened in Step 3 (Fig. 4). Fix shelf to
panel with the (3) Phillips head screws and lock
washers removed in step 2 (Fig. 5, C).
6.
Fully tighten the (2) screws loosened in step 3 (Fig.
5, D)
Installing Side Burner Valve
1.
Locate the igniter wire hanging from side burner and
plug it into the open socket in igniter module. (Fig. 6)
Note: If there is more than one open socket, call 1-
800-913-8999 for assistance.
2.
Locate the small wire emerging from the igniter
module and connect it to the terminal on the side
burner valve (Fig. 7).
3.
Remove two screws and washers from front of side
burner valve (Fig. 8, A)
4.
Insert rear stem of side burner valve into burner
tube hole (Fig. 8, B).
,
Insert front stem of side burner valve through hole in
side burner control panel (Fig. 8, A.), Insert and
tighten the (2) screws and washers from step 3
through the control panel bezel and into the side
burner valve (Fig. 8, A).
6.
Push side burner control knob onto side burner
valve control stem. Secure knob to stem by using
included hex wrench to tighten set screw (Fig. 9)
7.
Insert and tighten screw, washer and lock washer
removed in step 4 of Assembling Side Burner Shelf
(Fig. 5, E).
Figure 4
7
Figure 5
C
\
D
E
/
Figure 6
Advertisement
