Advertisement
7. Pull out the light bulb and replace with a new
bulb as Picture F, then tighten the four screws
which were loosen in picture E.
Note: Do not touch the halogen bulb with bare hands.
Picture F
8. Replace glass cover, reinsert light bulb housing into
the grill, and insert and tighten all the screws. Picture G.
Picture G
9. Attach original lamp rear cover with original 8pcs
screws and washers to back panel of firebox and
tighten screws as Picture H.
Picture H
Cleaning
Method
Follow steps 1 through 4 above for glass cover removal. Use a damp towel to clean the surface of the
glass cover. Make sure the glass cover is completely dry before re-installing.
Z_ WARNING
Make sure the light switch is in the "OFF" position and the power plug is disconnected from the
power outlet prior to cleaning the glass cover.
,/_ WARNING
The glass cover should not be in contact with water or any other liquid when it's warm. Sudden
change of temperature may cause cracks in the glass.
/'_
WARNING
To ensure continued protection against electric shock:
1. Connect to properly grounded outlets only.
2. Do not expose to rain.
3. Keep extension cord connections dry and off the ground.
Bulb Type: Halogen
Wattage: 10 watts per bulb
Voltage: 12 volts
If you still have questions about replacing bulb, call the Customer
Service Helpline 8 AM - 5 PM
PST, Monday through
Friday at 1-800-913-8999.
13
Advertisement
