Table of Contents
Advertisement
GeForce 9300/9400 ITX Series Motherboard
Front panel header-FP1
The front panel header on this motherboard is one connector used to connect the
following four cables.
q PWRLED
Attach the front panel power LED cable to these two pins of the connector. The
Power LED indicates the system's status.
q PWR SW
Attach the power button cable from the case to these two pins. Pressing the
power button on the front panel turns the system on and off rather than using the
power supply button.
q HDD LED
Attach the hard disk drive indicator LED cable to these two pins. The HDD
indicator LED indicates the activity status of the hard disks.
q RST SW
Attach the Reset switch cable from the front panel of the case to these two pins.
The system restarts when the RESET switch is pressed.
1
SPDIF
Note:Some chassis do not have all four cables.
Be sure to match the name on the connectors to the corresponding pins.
SPDIF-Out Header
This header provides a SPDIF-Out
(Sony/Philips Digital Interface) to
digital multimedia device through
coaxial connector.
14
121
121
+
120
240
120
240
SPDIF-Pin Definition
Pin
1
2
3
4
FP1-Pin Definition
Pin
Signal
1
HDD_LED+
2
PW_LED+
3
HDD_LED-
4
PW_LED-
5
GND
FP1
10
9
2
1
Signal
SPDIF OUT
VCC
NC
GND
Pin
Signal
6
PWR_SW
7
RESET
8
GND
9
NC
10
KEY
Hide quick links:
Advertisement
Table of Contents
