Installing Memory Dimms - Zotac GeForce 9300-ITX User Manual

GeForce 9300/9400 ITX Series Motherboard

Installing Memory DIMMs

Your new motherboard has two 1.5V 240-pin slots for DDR3 memory. These slots
support 1 GB/2 GB/4 GB DDR3 technologies. There must be at least one memory
bank populated to ensure normal operation. Use the following recommendations for
installing memory. (See Figure 1 for the location of the memory slots.)
q One DIMM:You can install the DIMM into any slot.
q Two DIMMs:Install into slot 1 and slot 2. The idea is to run on dual channel
mode.
Use the following procedure to install memory DIMMs into the slots on the mother-
board. Note that there is only one gap near the center of the DIMM slot. This slot
matches the slot on the memory DIMM to ensure the component is installed properly.
1. Unlock a DIMM slot by pressing the module clips outward.
2. Align the memory module to the DIMM slot, and insert the module vertically into
the DIMM slot. The plastic clips at both sides of the DIMM slot automatically lock
the DIMM into the connector.
10
+
121 121
DDRIII3
DDRIII1
120 240 120 240