Installing The Cpu Fan; Installing Memory Dimms - Zotac H55 - ITX wifi series User Manual

Installing the CPU Fan

There are many different fan types that can be used with this motherboard. Follow the instruction
that came with your fan assembly. Be sure that the fan orientation is correct for your chassis type
and your fan assembly.

Installing Memory DIMMs

Your new motherboard has two 1.5V 240-pin slots for DDR3 memory. These slots support 1
GB/2 GB/4 GB DDR3 technologies. They also support dual channel DDR3 memory technology
up to 10.7 GB/s. There must be at least one memory bank populated to ensure normal operation.
Refer to the following recommendations to install memory DIMMs.
q One DIMM: Install it into slot 1 or 2. You can install the DIMM into any slot, however, slot 1
is preferred.
q Two DIMMs: Install them into slot 1 and slot 2.
Refer to the following procedure to install memory DIMMs into the slots on the motherboard.
Note that there is only one gap near the center of the DIMM slot. This slot matches the slot on
the memory DIMM to ensure the component is installed properly.
1. Unlock a DIMM slot by pressing the module clips outward.
2. Align the memory module to the DIMM slot, and insert the module vertically into the DIMM
slot. The plastic clips at both sides of the DIMM slot automatically lock the DIMM into the
connector.
240 120
115XLM
REMOVE
121
Hardware Installation
240 120
DDRIII1
DDRIII2
121
11