What To Do If You See A Blank Screen - Epson PowerLite 821p User Manual

What To Do If You See a Blank Screen

If you see a blank screen or a blue screen with the message
after turning on your computer or video source, try the following:
Make sure the cables are connected correctly, as described in
Chapter 1.
Make sure the
Power
cap is off.
Make sure you've selected the correct image source; see page 32.
Allow a few seconds for the projector to sync up after pressing the
button.
Check the Signal menu to make sure the correct input source is
selected. See page 55.
If you're using a PC notebook:
Hold down the
Fn
display on an external monitor. It may have an icon such as
or it may be labelled
projector to sync up after pressing it. Check your notebook's
manual or online help for details.
On most systems, the
between the LCD screen and the projector, or display on both at
the same time.
If you're projecting from a notebook and you don't see the same
image on the projection screen and computer screen, check your
monitor settings to make sure both the LCD screen and the
external monitor port are enabled.
From the Control Panel, open the
tab, then click
Settings
the settings varies by brand; you may need to click a
then make sure the external Monitor port is set as your primary
display and/or enabled. See your computer's documentation or
online help for details.
light is green and not flashing and the lens
key and press the function key that lets you
. Allow a few seconds for the
CRT/LCD
or
CRT/LCD
Display
. The method for adjusting
Advanced
No Signal
key lets you toggle
utility. Click the
tab,
Monitor
Projecting
33