Epson PowerLite 5350 User Manual page 61

You can connect the projector to an S-Video source, a composite video
source, and a component video source at the same time. However, the
projector automatically selects the S-Video as the video source. To
display composite or component video, first disconnect the S-Video
source.
The projector supports HDTV, NTSC, PAL, and SECAM video
formats, and automatically detects and identifies the video format.
However, you can specify that a single broadcast format be detected.
(See Chapter 3.) Note that the projector will then be able to detect
only one type of video signal.
The type of cable you use to connect the video source to the projector
depends on whether you have composite video, S-Video, or
component video. For composite video, use the audio/video (A/V)
cable supplied with the projector. For S-Video, use the S-Video cable
supplied with your video device or obtain one from your computer or
video equipment dealer. For component video, use the BNC type
cable that came with your video source. The illustration below shows
the S-Video, component, and composite connectors.
S-Video
4-pin, mini-DIN
1 2
3 4
component
BNC connector
Connecting to a Video Source
composite
RCA
53