Epson PowerLite 53c Quick Setup

C
onnect the projector
to your laptop
For most setups, you'll need just these two cables:
Power cord
1
Make sure your projector and laptop are turned off.
2
Connect one end of the computer cable to the
Computer/Component Video port on the projector.
3
Connect the other end to your laptop's video or
If you can't connect the cable to your PowerBook,
to use an adapter. See your User's Guide for instructions.
T
urn on your equipment
1
Remove the lens cover.
2
Connect the power cord to your projector and plug
the other end into an electrical outlet.
3
Press the Power button. The Power light
flashes green, and then stays on.
4
Turn on or restart your laptop. (Windows
If you see this Add New Hardware screen,
click Cancel.)
Computer cable
Monitor Out Computer/
S-Video Video
Component Video
Control
Audio1 L Audio2 R
(RS-232C)
monitor port.
®
you may need
Lens cover
Power light
®
only:
EPSON

Quick Setup

Follow these instructions to connect the projector
to your laptop. To connect other devices, such as
a VCR, DVD, or desktop PC, see your User's Guide.
Caution: Before unplugging
the projector...
To shut the projector down properly:
1. Press the
Let the projector cool while the
Power light flashes orange
(about 45 seconds).
2. Once the light stops flashing and
stays on, it's safe to unplug
the projector.
Never unplug the projector when
the Power light is green or
flashing orange.
Turn over
® PowerLite ® 53c/73c
Power button twice.