Advertisement
Available languages
Available languages
5.
6.
Rotate each retaining clip clock-
wise and press down until it
snaps into place over the handle.
If the handle has excessive
movement,
it is improperly
installed. Check the following.
A.
Are both tabs inside the
handle (Step #3)?
B.
Does each clip pass through
both the saddle and handle
(Step #4)?
To Assemble
Wheels
It will be necessary
to brace or support
one side of the air compressor
when installing the wheels
because
the compressor
will have a tenden-
cy to tip.
1.
Attach wheels with shoulder
bolts and nuts as shown.
2.
Tighten securely. NOTE: The air
compressor will sit level if the
wheels are properly installed.
The wheels and
handle do not pro-
vide adequate
clearance,
stability
or support
for pulling the unit up
and down stairs or steps. The unit
must be lifted, or pushed up a
ramp.
Assemble
Rubber
Feet
1.
Attach rubber feet with the
screws, washers and nuts pro-
vided as shown in figure below.
2.
Tighten securely.
Nut
Wheel
To Add
Oil To Pump
Compressors
are
shipped
without oil.
A small amount of oil may be pres-
ent in the pump upon receipt
of the
air compressor.
This is due to plant
testing
and does not mean the
pump contains
oil. Do not attempt
to operate this air compressor
without
first adding oil to the
crankcase.
Serious damage
can
result from even limited
operation
unless filled with oil and broken
in
correctly.
Make sure to closely
fol-
low initial start-up
procedures.
Use air compressor
oil only. Multi=
Viscosity
motor
oils, like 10W 30,
should
not be used in an air corn=
pressor. They leave carbon
deposits
on critical components,
thus reducing
performance
and
compressor
life.
NOTE: Use an air compressor
oil
such as Sears item number 9-16426
or SAE-20 (API CG/CD heavy duty
motor oil. Under extreme winter con-
ditions use SAE-10 weight oil.
11- ENG
D24910
Advertisement
