Table of Contents
Advertisement
I
OTE: Theteethofthebladeshouldpointupward
at the front of the saw as
shown in (Fig+16)+
9+Place saw on the edge of a flat surface so the blade ts not in contact
with anything,
10, Raise lower blade guard using the blade guard lever and hoed it tn the raised
position for the next steps,
11+Replace the "D" washer.
12. Firmly hold down spindle lock button as you replace blade screw and hand
ttghten It in a clockwise direction. Then use blade wrench to tighten the blade
clamping screw thoroughly,
13_ Place blade wrench back tn case.
I
NOTE: NEVER use a blade that is too thick to allow the "D" washer to
I
engage with the flat slde of the spindle,
I
ABOUTTHE
BLADETHAT
COMES ON YOUR SAW
Failureto obey these warningscould read to serious bodily injuryor death
This saw comes with a Freud _ Avantl thin kerr 24 tooth carbide-tipped
steel
framing blade.
= Always wear eye protection complying
with current CSA
Standard Z94.1 or ANSI Standard Z87+I.
o Before each use, check that the blade is free from cracks, loose teeth,
missing teeth, or any other damage. • Do not use if damage is noticed or
suspected,
Do not use for cutting metal or masonry.
Keep body or clothing
clear of spinning blade.
• Set depth of blade slightly deeper than lumber° Mount blade securely
in
proper rotation direction. Never use a blade in the saw that will exceed the
maximum recommended
blade RPMs.
• Read and obey all warnings and instructions contained
in the saw's
operator's manual+ Only operate saw when proper saw guards and protections
are in place and working properly.
Properly secure workpiece
before cutting_
Allow saw to reach full speed before cutting.
= Keep this information
in a safe place for future reference,
= Some dust created by power sanding, sawing, grinding, drilling and other
activities contains
chemicals known to the state of California to cause cancer,
birth defects or other reproductive
harm.
25
Advertisement
Table of Contents
