Epson DREAMIO EH-DM3 User Manual page 64

When lights on red
Internal failure
Red
Wait for approximately 1 minute and 30 seconds.
Then, disconnect and reconnect the power cable.
Red
If the indicator status does not change when
Red
Fan related error/Sensor error
Red
Red
High temperature error
Red
(overheating)
The lamp turns off automatically and
projection stops. Wait for approximately 5
minutes. When the Power indicator color
Red
changes to orange, check for the 3 points
shown at right.
Lamp error/Lamp failure/Lamp cuts out
Red
Wait for approximately 1 minute and 30 seconds, and check for a blown lamp.
Clean the air filter and the air intake vent.
Red
The lamp is not broken
The lamp is broken
When using this unit at high altitudes, that is 1500 m or more above sea level, set "High Altitude Mode"
to "On".
Auto Iris Error
Red
Power Err. (Ballast)
Red
Red
62
is pressed and the power turned on...
Reinsert the lamp then turn on the main
power switch on the main unit.
Contact your dealer for further advice.
s
p. 59
Error
Disconnect the power cable from the electrical
outlet and contact your dealer.
• Move this unit away
from the wall by at
least 20 cm.
• Clean the air filter.
s
p. 66
• When using this unit
at high altitudes, that
is 1500 m or more
above sea level, set
"High Altitude Mode"
s
to "On".
s
p. 66
If the error continues
Wait for approximately 1 minute and 30
seconds. Then, disconnect the power cable
from the electrical outlet and contact your local
dealer or the nearest address provided in the
s
Inquiries. p. 80
If the indicator status
does not change when
is pressed and the
power turned on...
p. 59
s
p. 69
If the condition is not
fixed once the lamp is
re-inserted
s
p. 80
: lit : flashing : off