Craftsman 536.797420 Owner's Manual page 5

.'_'$:t=1_ I']_'
LL_ CAUTION: Always wear safety
glasses or eye shields while assembling
Edger/Tnmmer
TOOLS REQUIRED FOR ASSEMBLY
2 - 1/2 inch Wrenches
(or adjustable wrench)
2 - 9/16 inch Wrenches
(or adjustable wrenches)
2 - Adjustable Wrenches
1 - Regular Screwdriver
1 - Phers
The figure to the nght shows the Edger,'
Tnmmer completely assembled
References to the nght or left hand side
of the Edger_nmmer are from the view-
po=nt of the operator's position behind the
unit
TO REMOVE EDGERf'FRIMMER
FROM CARTON
• Remove the lower handle, control rod,
upper handle and packing matenal from
the carton
• Remove wheels, parts bags and packing
materlat from the carton
• Cut down all four corners of the carton
• Remove packing material from around
Edger/Trtmmer blade
TO ASSEMBLE THE EDGER/
TRIMMER
NOTE
Lower handle should be attached
first as it _sdifficult to attach lower handle
with the wheels on
• Place lower handle inside the Edger'
Trimmer frame as shown in top f_gure
and secure _n place with four 5q6-18x
5/8 inch hex head wide flange screws
and four 5/1 6-18 hex head IockmJtS
found _n parts bag Hold back on the
lower handle as you tighten the screws
Locknuts should be on the reside of lhe
frame as shown m middle figure of this
page
• Attach the right rear whee! to the wheel
support rod of the EdgertTr_mmer as
shown in lower figure on this page wrth a
1/2 x 3/4 inch Ilatwasher and cotter prn
found =n parts bag Bend ends of cotter
pin
Upper
Handle
,Clutch Lever
Slade Guard
Handle
Starter
Handle
Lower Handle
/.
5q6-18 X 5 8 inch _5/16.18
hexheadw_de ,H_xH_ad I
flange Screws
Frame _ ,
=0
m0
VIEW FROM RIGHT SIDE
Wheel
Flatwasher
1 '2_3 '4 inch
Cotter P=