Dram Configuration - Gigabyte GA-MA790GPT-UD3H User Manual

DRAM Configuration

DCTs Mode
DDR3 Timing Items
x CAS# latency
x RAS to CAS R/W Delay
x Row Precharge Time
x Minimum RAS Active Time
x 1T/2T Command Timing
x TwTr Command Delay
x Trfc0 for DIMM1
x Trfc2 for DIMM2
x Trfc1 for DIMM3
x Trfc3 for DIMM4
x Write Recovery Time
x Precharge Time
x Row Cycle Time
x RAS to RAS Delay
CHA ProcOdt
CHA DQS drive strength
CHA Data drive strength
higf : Move Enter: Select
F5: Previous Values
CHA MEMCLK drive strength
CHA Add/Cmd drive strength
CHA CS/ODT drive strength
CHA CKE drive strength
CHB ProcOdt
CHB DQS drive strength
CHB Data drive strength
CHB MEMCLK drive strength
CHB Add/Cmd drive strength
CHB CS/ODT drive strength
CHB CKE drive strength
Bank interleaving
Channel interleave
higf : Move Enter: Select
F5: Previous Values
DCTs Mode
Allows you to set memory control mode.
Ganged
Unganged
DDR3 Timing Items
Manual allows all DDR3 Timing items below to be configurable.
Options are: Auto (default), Manual.
CAS# latency
Options are: Auto (default), 4T~12T.
RAS to CAS R/W Delay
Options are: Auto (default), 5T~12T.
BIOS Setup
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
DRAM Configuration
[Unganged]
[Auto]
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
[Auto]
[Auto]
[Auto]
+/-/PU/PD: Value
F6: Fail-Safe Defaults
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
DRAM Configuration
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Enabled]
[Enabled]
+/-/PU/PD: Value
F6: Fail-Safe Defaults
Sets memory control mode to single dual-channel.
Sets memory control mode to two single-channel. (Default)
SPD Auto
7T 7T
7T 7T
7T 7T
30T 30T
-- --
5T 5T
90ns 90ns
-- --
-- --
-- --
10T 10T
5T 5T
28T 28T
4T 4T
60 ohms
1.0x
1.0x
F10: Save
1.5x
1.5x
1.5x
1.5x
60 ohms
1.0x
1.0x
1.5x
1.5x
1.5x
1.5x
F10: Save
- 42 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults