Gigabyte GA-MA790X-UD3P User Manual page 26

9) GSATA2_0/1 (SATA 3Gb/s Connectors, Controlled by GIGABYTE SATA2, Purple)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s
standard. Each SATA connector supports a single SATA device. The GIGABYTE SATA2 controller
supports RAID 0 and RAID 1. Refer to Chapter 5, "Configuring SATA Hard Drive(s)," for instructions
on configuring a RAID array.
A RAID 0 or RAID 1 configuration requires at
least two hard drives.
10) PWR_LED (System Power LED Header)
This header can be used to connect a system power LED on the chassis to indicate system power
status. The LED is on when the system is operating. The LED keeps blinking when the system is
in S1 sleep state. The LED is off when the system is in S3/S4 sleep state or powered off (S5).
GA-MA790X-UD3P Motherboard
1
GSATA2_0 GSATA2_1
1
- 26 -
Pin No.
1
2
3
4
7
5
6
7
Please connect the L-shaped end
of the SATA 3Gb/s cable to your
SATA hard drive.
Pin No. Definition
1 MPD+
2 MPD-
3 MPD-
System Status LED
S0 On
S1 Blinking
S3/S4/S5 Off
Definition
GND
TXP
TXN
GND
RXN
RXP
GND