Epson TM-U300C Operator's Manual page 23

Replacing the roll paper for TM-U300C/U300PC
Be sure to use roll paper that matches the printer's specifications. See Appendix
A, Specifications.
Open the take-up device cover.
Remove the take-up spool from the printer. (If it is necessary, cut the paper go-
ing to the take-up spool, using the tear-off edge.) Then remove the roll paper
core.
If there is roll paper remaining, cut the paper straight across using scissors at
the place shown in illustration below.
While pressing the FEED switch, remove the remaining roll paper in the printer
by pulling the paper lightly out in the direction of the arrow.
Cut here if there is paper remaini
To install a new paper roll, see Installing the paper roll in the TM-U300C/U300PC, on
page 11.
17