Table of Contents
Advertisement
Assembly
Removing or Installing the Blade
I WARNING: To avoid injury from a thrown work-
piece or thrown pieces of blade, do not use a
blade larger or smaller than 10" diameter,
1
1.
2.
WARNING:
To avoid injury from unexpected
starting,
unplug
the saw whenever
you are
removing or installing the blade.
Unplug the saw from the outlet.
Loosen the cover plate stop screw with phillips end
of the combination wrench, supplied.
3.
Lift the lower guard up and tilt the lower guard
assembly back so the arbor screw is exposed.
4a. For Model 1t3.235200
only, find the arbor lock
between the upper guard and the miter saw handle
press the arbor lock and hold it in firmly while turn-
ing the arbor screw. The arbor lock will
within one revolution
4b For either saw model you may lower the
down on to a scrap piece of wood positioned
against the fence. This will serve as an alternate
locking means.
5.
Place the 1/4" allen end of combination
wrench
supplied into the arbor screw. Remove the arbor
screw, outer blade collar, and the blade.
NOTE: Pay attention to pieces removed, noting their
position and direction they face (see illustration). Wipe
the blade collars clean of any sawdust before installing
a new blade.
6.
Install the new 10" blade (see recommended
accessory list). Make sure the rotation arrow on the
blade matches the clockwise rotation arrow on the
upper guard.
7
Install the outer blade collar, and arbor screw. Turn
the allen wrench counter clockwise to secure the
blade. Tighten arbor screw securely.
8.
Lower the lower blade guard until the slot in cover
plate rests all the way down on the coverplate stop
screw. Tighten the screw with phillips end of the
combination wrench, supplied.
DANGER:
Never use saw without cover plate
securely in place. It keeps the arbor screw from
falling out if it accidentally
loosens, and pre-
vents the spinning blade from coming off the
machine,
9.
Be sure the arbor lock is released so the blade
turns freely.
NOTE: On Model _13.235200, the arbor lock can be
damaged by improper use.
/
MITER SAW
HANDLE
COVER PLATE
ARBOR
SCREW
ARBOR
LOCK
LEFT HAND THREAD
COVER PLATE
STOPSCREW
UPPER
BLADE
GUARD
BLADE
"COLLARS
BLADE COLLARS
BLADE
COLLAR
WARNING: Make sure the collars are clean and
properly arranged. After installing a new blade,
make sure the blade clears the table slot at the
0 ° and 450 bevel positions,
Lower the blade
into the lower table and check for any contact
with the base or turn table structure.
ARBOR
SCREW
BLADE
9
Hide quick links:
Advertisement
Table of Contents
