Basic Saw Operations (Continued)
Miter Cut
E
When a miter cut is required,
loosen the miter lock
knob, depress the index spring, and move the saw to
the desired angle. Retighten miter lock knob. Do not
stand in front of the saw table. Move with the handle to
the miter angle to make the cut.
i ':
tj
MOVEFEET
WITH MITER
ANGLE
Bevel Cut
Model
113.235200
Compound
Miter Saw
Only:
When a bevel cut is required, loosen bevel lock knob,
tilt the blade to desired bevel angle. Lock the bevel lock
knob. Stand to the left side of the handle to make the
cut.
Overriding the Bevel Stops
Use the 0 ° and 45 ° bevel stops for precise, repeatable
bevel indexing,
Occasionally, when cutting a bevel or compound cut,
you may need to set the bevel angle a small amount
beyond the 0 ° or 45 ° bevel stop, This is very easily
done by pulling the bevel index pin out and mockingthe
bevel knob.
BEVEL
LOCK KNOB
BEVELINOEX
PiN
\
REAR, BOttOM
VIEW FROM BACK
BEVELINDEX
STOPS
17