Assembly And Alignment; Both Models; Item Description Qty; Hex Nut 1/4 -20 - Sears Craftsman 113.248211 Owner's Manual

assembly and alignment
BOTH MODELS
ATTACHING LEVELING FEET
From the loose parts bag find the following hardware:
ITEM DESCRIPTION QTY.
A Support Bracket ............................................. 4
B Leveling Feet .................................................. 4
C Hex Nut 3/8-16 ............................................... 8
From the loose parts find the following items:
D Leg ................................................................. 4
*U
*D
*NOT SHOWN TO SCALE
1. Mount floor leveler support brackets inside legs.
Line up the three tabs on brackels with slots on leg
and tap into place. Make sure lip on bracket points
up. Install the remaining three brackets the same
way.
¢
-- LEG
®
="l"
SUPPORTBRACKET
2 Put a hex nut on each of the !eveling feet and screw it
down towards the rubber foot.
3, Put the leveling feet through the holes in the bottom
of the tloor leveler support bracket.
4, Put another hex nut on each of the leveling feet and
hand tighten until they are next to the support bracket.
I WARNING: After the legset has been attached to
the basic saw assembly, it will be necessary to
adjust the leveling feet so the saw does not rock.
EX NUTS
I
SUPPORT BRACKET _
LEVELING FOOT
11