Craftsman CYCLONE 900.11684 Instruction Manual page 5

Environmental Safety
• Paint should be removed in such a manner
as to minimize the amount of dust generated.
• Areas where paint removal is occurring
should be sealed with plastic sheeting of 4
mils thickness.
• Sanding should be done in a manner to
reduce tracking of paint dust outside the
work area.
Cleaning and Disposal
• All surfaces in the work area should be
vacuumed and thoroughly cleaned daily for
the duration of the sanding project. Vacuum
filter bags should be changed frequently.
• Plastic drop cloths should be gathered up
and disposed of along with any dust chips
or other removal debris. They should be
placed in sealed refuse receptacles and
disposed of through regular trash pick-up
procedures. During clean up, children and
pregnant women should be kept away from
the immediate work area.
• All toys, washable furniture and utensils
used by children should be washed
thoroughly before being used again.
Assembly
_Warning: Before assembly, make sure
that the tool is switched off and
unplugged.
Random Orbit Sanding Base
With this sanding base, you can use the toot
as a random orbit sander.
Fitting and removing the sanding
base{fig. B)
• Place the sanding base (3) onto the spindle
(10).
• Place the washer (7) onto the spindle.
• Insert the hex screw (8) into the screw hole
in the spindle.
• Tighten the hex screw using the Hex key (9)
supplied.
• To remove the sanding base, remove the
hex screw (8) and washer (7).
Fitting sanding sheets (fig. C)
• Hold the toot with the sanding base (3)
facing upwards.
• Place the sanding sheet (11) onto the
sanding base (3). The holes in the sheet
do not need to line up with the holes in the
base.
3
Large Detail Sanding Base
With this sanding base, you can use the
tool as a detail sander, a finish sander or a
flush finish sander.
Fittinq and removing the sanding
base'(fig. D & E)
For detail sanding, the pointed end should
face forward as in fig. D. For sanding large
areas, the pointed end should face to the
back as in fig. E.
• Place the sanding base (12) onto the
spindle (10). Make sure that the legs of
the base locate into the tool.
• Place the washer (7) onto the spindle.
• Insert the hex screw (8) into the screw
hole in the spindle.
• Tighten the Hex screw using the Hex key
(9) supplied.
• To remove the sanding base, remove the
hex screw (8) and washer (7).