Craftsman 139.536481DM Owner's Manual page 24

ONE-PIECE DOORS
Pleaseread and comply with the warnings and reinforcement
instructions on the previous page. They apply to one-piece doors
also.
• Centerthe door bracket on the top of the door, in line with the
header bracket as shown. Mark either the left and right, or the
top and bottom holes.
• Drill 5/16" pilot holes and fasten the bracket with hardware
supplied.
If the door has no exposed framing, drill 3/16" pilot holes and
fasten the bracket with 5/16"x1-1/2" lag screws (not provided) to
the top of the door.
NOTE:Thedoor bracket may be installed on the top edge of the
door if required for your installation. (Refer to the dotted line
optional placement drawing.) Drill 3/16" pilot holes and substitute
5/16"x1-1/2" lag screws (not provided) to fasten the bracket
to the door.
HARDWARESHOWN ACTUALSIZE
Nut 5/16"-18 LockWasher 5/16"
Carriage Bolt
5/16"-18x2-1/2"
HeaderWall
2x4 Supper
-- Finished Ceiling --
Header
Bracket
Optional
Placement
of Door
Bracket
Door
Bracket
Vertical
Centerline of
Garage Door
Horizontal and vertical
reinforcement is needed for
lightweight garage doors
(fiberglass, aluminum, steel,
door with glass panel, etc.).
(Not Provided)
For a door with no exposed framing,
or for the optional installation, use
5/16"x1-1/2" lag screws (Not Provided)
to fasten door bracket.
Nut - -e¢
5/16,,-18 ÷ ' LoekWasher
i 5/16"
Door , ! Top of Door
Bracket __de Garage)
"__.P_. J_l_TOp Edge
of Deer
",_,_// J Optional
', Placement
Carriage Bolt i i
5/16"-18x2-1/2"
24