Advertisement
On back of grill, place upper back panel between side panels and above lower back panel. Secure upper back panel, in
lower holes, using one114-20x11/2 ' ' screw and 7mm lock washer on each side. In upper holes, using one 1/4-20xll/2 ''
screw and 7ram lock washer on each side, shown A. In the cart, secure upper back panel to lower back panel using
one 114-20x112"screw and 7ram lock washer, shown B.
ll4-20xll2"Screw
7ram Lock washer
Qty.1
Oty.5
1/4-20x 1V2" screw
Qty.4
screw
screw
7ram_&
Jock
washer
_1/4-20x112
screw
First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner
valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes
on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.
Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on
fascia, making sure "OFF" is on the top. Attach using two #8-32x3/8" screws and 4ram lock washers. Press sideburner
control knob onto valve stem.
/J
Lock washerj
/"
]/
Sideburner
valve bracket
4ram lock washer
#8-32×3/8" screw
Qty.2
Qty.2
Control knob bezeJ
Note: Use upper and lower
holes on fascia to
attach bezel
4ram
lock washer
#8-32x3/8" screw
Sideburner control knob
Advertisement
