Operation; Using The Dryer - Bosch Nexxt Premium Gas Operating, Care And Installation Instructions Manual

Operation
Using the dryer
1. Open the door.
Meno Select
Additional Options
%
[
If you have chosen a time
program don't forget to select
a time. Otherwise the
"Start/Stop" indicator light wilt
not flash and the dryer will not
start.
If the door has not been closed
properly, the dryer wilt not start.
2. Check tint filter.
The filter should be cleaned
after and before every drying
process. Cleaning the filter
reduces the drying time and
saves energy.
i
3. Rotate program selector to the
desired program.
Select the program which
corresponds to the laundry in
the dryer from the program
selection table (see page 21).
The dryer light turns on inside
the drum.
]]]The estimated remaining time
will be indicated.
[_3 Lint filter indicator flashes for
5 seconds "Check tint fitter"!
4. Select "Additional Options" on
the display.
More detailed information on
the individual additional options
can be found on page 19.
5. If required, select "Option" by
pressing the button.
The "Options" are explained on
page 20.
E_The estimated remaining time
wilt be updated.
6. Place laundry in the empty
drum. Put each piece of laundry
into the machine separately.
For best results the laundry to
be dried must be sorted
according to type of laundry
and desired degree of drying.
For further information see
page 18.
[_ Observe drying symbols of the
laundry manufacturer.
If drying woolen clothing and
shoes, see the information on
page 17 and page 23.
Ensure that there is only laundry in
the drum. Check that all items are
completely in the drum.
7. Close the door.
The "Start/Stop" indicator light
starts flashing.
8. Press the "Start/Stop" button.
The "Start/Stop" indicator light
illuminates.
[_The program starts with an
acoustic signal (if set).
If an automatic program has been
selected, the indicator lights
indicate the progress of the
program sequence.
[_At the end of the program
sequence damp dry an
acoustic signal is emitted
(if set).
J :
[
[
At program end an acoustic
signal is emitted (if set) and the
LED "wrinkle block/finished"
illuminates,
When the drying process is
complete (program or selected
time program ended), the drum
rotates at specific intervals.
This prevent the laundry from
creasing (see "Extended
Wrinkle Block", page 20).
22