Load Paper; Install Software - Epson Stylus Photo R320 Start Here Manual

4
4

Load Paper

Load Paper
1
Fan a few sheets of paper and load them against
the right side of the sheet feeder.
2
Slide the left edge guide against the paper.
NOTE: For instructions on loading and printing
on CDs or DVDs, see your Printer Basics book.
5
5

Install Software

Install Software
Windows
®
The software works with Windows 98SE, Me, 2000, and XP. Make sure your printer is NOT
connected to your computer, then follow the steps below.
1
Turn on your computer. Wait for the system
to start up, then insert the Epson
in your drive.
NOTE: If you see a screen like this,
click Cancel and disconnect the
printer from your computer. Then
follow the steps below.
2
Read the license agreement that appears
and click AGREE.
3
You see a message like this:
Click OK to begin installing your printer driver.
4
When you see this screen, connect the
end of your USB cable to the back of the printer and
the flat end of the USB cable to your
computer. (You can connect to any open port.)
NOTE: For Windows XP, if you don't have USB 2.0,
you see a message. Click the Close button to close
the message.
Wait while Windows detects your hardware.
5
When you see this screen, click Continue.
6
Follow the on-screen instructions to
install your software.
® CD-ROM
Square end
square
Flat end
continue