A
A-10 Color Measurement Instruments
T
O CONNECT THE
1. Turn off the computer.
2. Plug the square end of the interface cable (looks like a modular phone plug) into the
3. Attach the connector to the computer.
Unused connector
Connect to computer
Connect to adapter
Setting up the DTP32
Before you calibrate the EX7750 using the X-Rite DTP32, you need to connect,
configure, and calibrate the densitometer to prepare for measuring the printed patches
(see
"Calibrating the DTP32"
up and using the DTP32, see the documentation that accompanies the densitometer.
X-R
DTP32
ITE
TO THE COMPUTER
I/O port on the side of the X-Rite DTP32.
For a Windows computer, insert the 8-pin mini-DIN end of the interface cable into
the 9-pin DB9 Connector cable adapter. Insert the 9-pin end into the COM1 or
COM2 port on the computer and tighten the screws. If the available port on your
computer is 25-pin, you must use the 8-pin-to-25-pin adapter.
on page A-12). For additional information about setting
Square connector
Square connector
Interface cable