Zenith L26W56SA Installation And Operating Manual page 56

Warning: Do not use LT2002 while a LodgeNet PPV
card is installed in TV or clone programmer will be
damaged.
Reset CLone After Static Shock
After replacing exhausted batteries, or if the programmer
behaves strangely after a static shock, activate the
internal reset switch and restore normal operation.
After a reset, check the real-time dock setting. It may
be necessary to reset the CLone Programmer clock from a
TV containing the correct time.
Note
The LT2002 programmer is designed to be used with TVs con-
taining the 221-01006 and Later processors. Use with earlier TV
sets may give unpredictable results. Processors used before the
221-01006-04 have a Limited screen display capability. They
cannot display entire screens as shown in the quick setup
instructions accompanying the LT2002 clone programmer. Use
the printed menu illustrations on the quick setup sheet supplied
with the Clone as an aid to making your programming choices.
(ALthough the menus are not all displayed, the clone functions
all operate normally.)
CLone Programmer Troubleshooting
CLone Programmer
CLoning Notes: While clone is copying or transferring a master setup, do not touch or otherwise disturb clone or connections between clone
and IV. Cloning a master IV setup should take at Least 45 seconds. Transferring the master TV setup to the target TV should take at Least 45
seconds. Monitor LED on clone to assure that the blinking heartbeat pattern is present throughout clone operations. After cloning, be
sure to disconnect power from the target TV for about 15 seconds.
Problem Possible Cause(s)
Remote does not • Wrong Installer remote,
operate clone.
LED does not blink. • M.P.T. curd not connected.
• L26W56XA not turned on.
• Weak batteries.
• Weak signal.
CLone menu hard to
read.
No time set. • Time not available.
Possible Solution (s)
- Only use an appropriate Installer remote to operate clone program-
mer with L26W56XA.
- Connect N.P,]. cord.
- L26W56XA must be powered On for clone to work.
- Install 4 fresh AA high-quality alkaline batteries.
- Connect L26W56XA to a reliable Analog channel signal source.
- Set time on a TV, copy time to CLone Programmer.
CLone not working.
Clone Scans Channels
more than once.
• Clone programmer problem.
• CLone should only scan
channels once.
- Trya different LT2002 Clone programmer.
ResetCLone Programmer.
- Retrycloningagain.
Master and Other L26W56XA
CLoning did not work.
CLone time disappeared.
New Setup not present.
• Procedure interrupted.
• Different TV models.
• Step(s) omitted or not performed.
• Insufficient cloning time.
• Cloning erratic.
• Batteries were removed.
• L26W56XA not reset.
- Wait until procedure complete message is displayed.
- CLoningis only possible with identical m odel TVs.
- Reread40 - 41 - 42 pages to be surealltaskswere performed.
- Redo cloning and be sure learning/teaching time is about I min. and
5 to15 seconds (75 seconds).
- ResetClone Programmer.
- Batteries must remain installed Lo retain time settings.
- Disconnectnewly cloned unitfrom power for 5 seconds.
• After cloning operations are complete, lust unplug the LT2002 from the L26W56XA.
• If the L26W56XA does not display a picture on the TV (blank screen) after a few seconds, lust change channels.
PAGE 56