Zenith L26W56SA Installation And Operating Manual page 40

Connections fortheLT2002 Crone Programmer to Learn t heL26W56XA Master TV
Setup.
I
Antenna
or CATV
i
I
I
I
Warning: Do not use LT2002
if a LodgeNet PPV card is
installed in TV or clone
prograramer device wf[[
damaged,
/
i
I
I
I
I
I
!
Ferrite Core
(TDK, ZCAT
2035°0930)
\
I
I
/
|
O_Se_ # Progta:m_
LT2_2
Clone Programmer
Master L26W56XA
*Notes: It is assunr_i that the L25_/56XA is connected to a signal source, the sour_:eselected is Antenna (R#) In, the sonal is ,from an
Analog channel, not a digital channel, ell equipment is connected to power and turned on and the LT2002 Clone
Programmer main menu (THE CLONEftAS CONTROL OF [fie TV) nrenu is displaved on the TV screen, the clone programmer LED is blinking
the required heanf beat pattern, see above and n_t page,
*Notes: Once the clone is connected, do not touch d_e unit or otherwise disturb it or the I_PI connections. Any disturbance while the
clone is operating nruy disrupt the master setup trano{er or cof4ying etc
Before you begin cloning...
• The Master L26W56XA should be connected to a good, stab|e
signa[ from an oven-the-air antenna or cable service
channel and connected to power. (See above.)
• Teaching and Learning is only possib{e between identical mode[
devices. (However; the LT2002 Clone programmer can store up
to 3 different 'master' setups,)
WARNING: Copying a b[ank or incon-ect memory into a TV, STB or
other devk:e wi[[ cause the 'fV, STB or other device to operate
erratica[[y or become inoperable,
Use an Insta{[er's remote to operate Learning and Teaching
menus.
• Make sure that the batteries in the C[one programmer are fresh.
• If batteries are removed, the Clone Clock time wi[t be {as[,
Decide if you want to set the time ram the C|one programmer
IV which has the dock set to the cun-ent time.
• Setting the time and transferring it to the Clone or other
device is a sepal'ate procedure_
Follow the connection diagram above to connect the Clone to
a Master L26W56XA W disp[ay panel After teaming is
complete, to another identical L26W56XA TV display pane[ to
"teach" it the master setup.
" After the L26W56XAs setup has been copied to another
identica{ L26W56XA, that ident]ca{ unit with the copied setup,
needs to be disconnected from power for about 15 seconds to
activate the new[y-copied setup.
See the Clone Troub[eshooting section to reso[_e prob[ems.
Turnto the next pageto continueCtoning Setup.
PAG E 40