Zenith A50M84W Operating Manual page 38

P 381 I
F
Usethe remote
control
search aLL
possiblecodes.
If Programming the Remotedid not find your
code, by this procedure to automaticaLLy find
the code for your device. If your remote
becomesinoperable, go backto "Programming
your Remote"and enter the Zenith TVcodefor
step five.
Turnon the device you're
programmingfor the
remote controL.
Pressand hold the PRGkey until
the indicator Lightturns on.
Pressthe keyfor the deviceyou're
trying to program(CABLE, V CR,
AUX,TV).
Enterthe code 0-0-0 (zero-zero-
zero), then pressthe ENTER key
right away.
Aim the remote at the correct
device and pressthe POWER
button. ALLow a secondto pass,
then pushthe POWER button
again. Repeat until the device
turns off. (This is a trial and error
process, s o it may be necessary to
repeat these steps until the
remotefinds your code.)
Push ENTER to save the code.The
indicator tight wiLL flash 3 times
and then turn off.
PressPOWER to turn the device
backon.
You canquay getout oJlento
find by pressingthe PRGbuttvn.
ff theindiceeor _ht stayson
wh_ie you push Power,instead
of turrWng off, oll the _ hove
been tried and your devicecan't
be progrommed.
\
/
_-_KQ-_