Table of Contents
Advertisement
SETUP MENU
I o Access SE'I Ui" Menu
Refer to the "Using On-Screen
Menus" section for details.
Before Using SETUP Menu
Connect and turn ON all external
equipment, such as cable TV decoder,
VCR, etc. before using any item on
the SETUP Menu.
SETUP
[AUTO PROGRAM
CH. ADD/DEL
CH. LABELS
TUNING
BAND
AUTO TUNING
SOURCE
ID
CLOCK
SET
CAPTIONS
Main Setup Menu
SETUP
ISOURCEID
CLOCK
SET
CAPTIONS
Setup Menu for Video
and S-Video Sources
AUTO PROGRAM
Purpose
Finds all available channels and stores them in the memory of
the TV for use by CHANNEL (CH) Up/Down.
Use AUTO PROGRAM only when you first install your TV,
or when you permanently change the connections to the TV.
For example, when you replace the antenna with a cable-TV
system.
NOTE:
AUTO PROGRAM can only be used with ANT/
CABLE 1 or 2 Source selection.
To Use AUTO
PROGRAM
l°
2,
Press
ADJUST
(ADJ)
Left/Right
to start
Auto
Pro-
gram.
Use
AUTO
PROGRAM
independently
for each
AN-
TENNA
or CABLE
signal
source
connected
to your
TV. Select
one source
by using
the SOURCE
MENU
(ANT/CABLE
1 or 2) and use AUTO
PROGRAM.
When
completed,
select
the
other
source
and
use
AUTO
PROGRAM
again.
CH. (Channel)
ADD/DEL
Purpose
Lets you add channels to and remove channels from the chan-
nel scan. In this way you can customize the channels that are
accessed through CHANNEL (CH) Up/Down.
NOTE: CH. ADD/DEL can only be used with ANT/CABLE
1 or 2 Source selection.
To Add a Channel to Scan Sequence
I.
Press ADJUST (ADJ) Left/Right to view the channel
add/delete
screen.
2.
Use the number buttons
on the remote to enter the
channel or use ADJUST
(ADJ)
Left/Right
and SE-
LECT Up/Down to move the highlight
to the channel
you wish to add.
3.
Add the channel by pressing
SOURCE until the dis-
play shows ADDED.
/_UTOPROGRAM I [
SrART
CH. ADD/DEL
CH.LABELS
TUNINGBAND
AUTO TUNING
SOURCE ID
CLOCKSET
CAPTIONS
Selecting Auto Program
When Some Channels
Are Not Found
AUTO PROGRAM
finds only active channels
and stores
them in the favorite channel memory.
You can add channels
to
those stored in memory
by using CH. ADD/DEL.
1
_ CH15ADD
LUTOPROGRAM
ICH. ADD/DEL
CH. LABELS
TUNING BAND
AUTO TUNING
SOURCE ID
CLOCK SET
CAPTIONS
Selecting Ch. Add/Del
To Delete a Channel from Scan Sequence
1.
Press ADJUST (ADJ) Left/Right to view the channel
add/delete screen.
2.
Use the number buttons
on the remote to enter the
channel or use ADJUST
(ADJ)
Left/Right
and SE-
LECT Up/Down
to move the highlight
to the channel
you wish to delete.
3.
Delete the channel by pressing
SOURCE
until the
display shows DELETED.
(continued on next page)
7--1
.: 3(b
o
Advertisement
Table of Contents
