JVC RV-NB20W Instructions Manual page 35

Using the remote control only
Press MUTING.
"MUTING" appears on tile display.
MUTING
On remote control
iii ...... "ii:2
'I' I ", I"I
I
iii iii
To restore the sound, press MUTING again or adjust tile volume
(see page 7).
During play, you can adjust tile bass level between BASS 1
(nfininmnl) and BASS 6 (maxinmnl).
Using the system
Turn the SUPER WOOFER VOLUME +/-
control
clockwise to increase the bass level
or turn it counterclockwise to decrease the
bass level.
SUPER WOOFER_
VOLUME ///S/ I \_\\
J:::i ."'"'.' ':::: ' ....'""i:::
||||| |
I,,,' I I ',,,' ',,,' ',,,'
Using the remote control
Press SUPER WOOFER VOLUME + to
increase the bass level or press SUPER
WOOFER
VOLUME
- to decrease it.
SUPER /
WOOFER _"k
VOLUM_
-,,,,
'"I'"1 '" '" '"
:::, . .-..:,.:, h...
Note: This function is not effective when tile headphones are in
use.
Sound modes can be selected to enhance tile type of music being
played.
Press SOUND to select the sound mode.
Each time you press tile button, tile sound mode changes as
follows:
F I.,, i:=1 T,[ii E
I::1 i * F:'
r.)F.', (_; L. E i:ii:_:
It I
SOUND
On system
SOUND
or
On remote control
Sound mode selection:
BEAT:
POP:
CLEAR:
FLAT (no effect):
Set to this position tbr music with a heavy
beat, such as rock and disco music.
Set to this position for light music including
popular and vocal music.
Set to this position tbr crisp and clear
sounding music with transparent highs.
Set to this position not to apply any sound
mode.
While the power is turned on, you can see tile current time (clock)
at any time, as follows.
Using the remote control only
Press DISPLAY.
Each time you press tile button, tile display changes as follows:
III
i.... ':' 'i :'",1 i i M, :"':
" = '"1 r"i i
zb ZzzzZ z z z
MH_
Current sound source (e.g. FM103.5 MHz) Z (clock)
Note: To let the clock work, you need to set the clock first. (See
"Setting the clock" on page 15.)
Tile Active Clear Sound (ACS) circuit emphasizes high-frequency
sound without lowering the signal-noise ratio, while adjusting its
output according to the input signal level. This results in a better
balance between the high-frequency sound and the low-frequency
heavy bass.
Press ACS (active clear sound) to turn it on
or off.
When it is turned on, tile ACS ON indicator lights in red.
ACTIVE _ J f/
CLEANSOUND _ rACS.I
_ ON ;EVEL
© O
or /_ _._
On system On remote control
• Tile ACS LEVEL
indicator flashes in green according to tile
input signal level.
8