JVC RV-NB20W Instructions Manual page 10

Basic operations
(.D/I ON/STANDBY
DISPLAY
SUPER WOOFER
+/-
MUTING
VOLUME +/-
(L)/I ON/STANDBY
ACTIVE CLEAR
SOUND
STANDBY lamp
ACS ON/LEVEL
indicator
Note: Tile lighting condition tBr tile STANDBY lamp and tBr tile
display differs depending on the power source.
Power source STANDBY lamp/display
• AC power • Tile STANDBY lamp lights when power is
turned off.
• Backtighting of the display is illuminated
when power is turned on.
• Batteries or car •
battery
(DC 12V)*
The STANDBY lamp does not light.
Backtighting of the display is not
illuminated.
With the system turned off (at standby), no
indication is shown on the display.
If no source is playing and no operation is done tBr about 4
minutes, "DC OFF" starts flashing on the display for about one
nlinute betBre the systenl turns off automatically (except when
the source is FM/AM or AUX, or when the microphone/guitar is
used).
Turnin= on the system
Press _/I ON/STANDBY.
• When the system is operated on batteries or car battelT (DC 12V),
press (L)/I ON/STANDBY on the system.
The STANDBY lamp goes off when the system is operated on AC
power.
The display comes on and the system is ready to continue in the
mode it was in when the power was last turned off.
I ON/
0/I STANDBY
On system
or
ON/STANDBY
©/I
STANDBY
On remote control
Turnin= off the system
Press flO/I ON/STANDBY again.
The STANDBY lamp lights up when the system is operated on AC
power.
• When the AC power is used, the CLOCK indicator and the time
are displayed without backtighting.
I ON/
© / I STA.DB¥ O_STA.DB¥ j
-- STANDBY --
or _" I _"
On system On remote control
N Some power is always consumed even though power is turned
off (called standby mode).
N To disconnect the system from mains (AC) supply completely,
unplug the AC power cord from the AC outlet. When you
unplug the AC power cord, the clock will be reset to
"AM 12:00" if no memolT backup batteries are installed.
You can adjust tile volume level between 0 and 50.
Using the system
Turn the VOLUME +/- control clockwise to
increase the volume or turn it
counterclockwise to decrease the volume.
I, ,,, .......
| | | | | | ||
| | | |
||||
| | | | | | ||| ||||| ||||| ||| |||||
Using the remote control
Press VOLUME + to increase the volume or
press VOLUME - to decrease it.
When you press and hold VOLUME + or , tile volume changes
rapidly.
CAUTION:
DO NOT start playing any source without setting
the volume to minimum first, as a sudden blast of
sound can damage your hearing, speakers and/or
headphones.
N For private listening
Connect a pair of headphones to tile PHONES jack on tile rear of
the system (see page 5). No sound comes out of the speakers.
Be sure to turn down the volume before connecting or putting on
tile headphones.
7