JVC RV-NB20W Instructions Manual page 17

Listening to auxiliary equipment
AUX --
LINK
AUX
You can listen to auxiliary equipment.
First make sure that tile auxiliary equipment is properly connected to tile system. (See pages 5 and 6.)
Note: For operation of the auxiliary equipment, refer to its instructions.
g Set the volume level to minimum.
2. Press AUX.
"AUX" appears on tile display.
f'iii","
"' ., I' 'l
• To listen to the auxiliary equipment, start playing the
auxiliary equipment.
,", I I I
i..,ii X
I I',,, I I
\--i--/ j
."'. _ Bubbles appear when the
mmm m m
-- mmmmm m mmmm mmmmm --
........ system detects the sound
J /_i_ X _ signal.
Adjust the volume to the desired listening
level.
Apply sound effects, if you wish.
• Adjust the super woofer volmne to reinforce tile bass sound.
Quick Portable Link (QP Link) automatically switches tile source
to AUX as the auxiliary equipment connected to the AUX .jack
starts playback.
Using the remote control only
To activate QP Link
Press QP LINK repeatedly to show "QPL
ON" on the display.
Tile QP LINK indicator appears on tile display in tile tMlowing
cases to inform you that QP Link is ready to work:
When an auxiliary equipment is connected to the AUX .jack.
When AUX is selected as the source.
,rr_ iiii:F
To cancel, press QP LINK repeatedly to show "QPL OFF" on tile
display.
"""" r...i" F
mm mm |mmmmm m _ mmm
| mmm
., -' .., I
How does QP Link work?
While QP Link is activated, starting playback pert_rms tile
following:
While listening to another source,
Changes the source to AUX.
When the power is supplied through the AC outlet and the
system is turned off,
Turns on the system and selects AUX as the source.
NOTES:
• When the sound signal fronl the auxiliary equipment is too weak,
QP Link may not function correctly. In this case, turn up the
volume of the auxiliary equipment so that the system can detect
the sound signal properly.
• If you change the source from AUX with QP Link turned on, QP
Link will be deactivated temporarily. In this case, the following
reactivate QP Link:
When the auxiliary equipment is unplugged from the AUX
.jack, then plugged in again.
When the sound signal from AUX jack stops or becomes very
weak tbr about 30 seconds.
• If the system is turned off while QP Link is working, QP Link
will be deactivated temporarily. In this case, QP Link is
reactivated when the sound signal from AUX .jack stops or
becomes very weak for about 30 seconds after the system is
turned off.
• While QP Link is activated, QP Link may start working when
you .just connect the auxiliary equipment to the AUX .jack or
unplug it. This is not a malfunction.
You can change tile AUX .jack sensitivity when QP Link
mistakenly works with detecting non-playback signals from the
auxiliary equipment, such as its switching noise.
Using the remote control only
Press and hold QP LINK.
Each time you press and hold QP LINK, tile sensitivity level
changes between QPL LV1 and QPL LV2.
QPLINK
iiiii rill iiiii
iI iI _1111 I
Iii i I
., , ... ... .%.
QPL LV1 : Normally select this (initial setting).
QPL LV2: Select this when QP Link works mistakenly.
14